Great design. Fits the radio well with space for addition kit. Next project will be remixing variants for some of my other handies.

Nice design. I particularly liked the Bambu Lab logo on the side, but found them a bit of a pain to attach. The only minor issue I found is that it tends to slip and slide around on the shelf. I may look at fitting some TPU feet to increase the grip.

Great design. I printed all three variants as I have a number of different spools from differnet manufacturers. Works like a charm.

Great design, really useful. Bonus, they fit in my top mounted pliers holder. Would have liked to print the upgraded version with TPU jaws and handles, but my current TPU is not AMS compatible. That's the next project.

Good design. Printed in transparent PLA, with the centre sections in transparent PETG to hold the Hydros. Had to take the AMS off the cross bar as the enclosure was hitting the locking nut. I have seen designs for low profile locking nuts, but I chose to wall mount it instead. When it's all together, sealed, and filled with silica gel, it sits at about 38-40% humidity (which is slightly lower than the room's avergae of 50%. Next step will be to print some TPU seals and see if that helps keep the humidity lower.

Great design. Printed the high infill bracket. Only point to note is that the AMS bracket is a little loose on the pivot, which causes a little instability and makes the AMS swing back and forth during printing.

Great design. My fit was a little loose, but using the tube numbers I've printed previously I was able to lock them in place. Works like a charm.

Great design. A bit of trouble to fit as I didn't think it through, but entirely my fault. Note to self: Mount the clamp, then position the bin base, slide the clamp down to lock the base in place, then fit the AMS support!

Great design, fits well. Fit's over the rasied screws on the newer A1 with a bit of encouragement. In future, I may try a remix to create indents so it fits tight over the screws.