I printed these at 145%, I didn't adjust the thickness, just left it. the only thing I kind of had problems with is woidstock holding the flower, not sure why, I just took a exacto knife and trimmed the little square just slightly. the other piece took a little bit of pressure to get them in. only reason I'm not giving it 5 stars, is it needs something to help keep the door shut.

great as always did the moss green and brown first and wasn't a total fan, so I redid it.

printed perfectly and it went together just fine no issues

printed perfectly only suggest if possible adding more of the squares (like you have on the new models) to help keep it aligned while the glue dries.

she turned out amazing. the only thing is supports are hard to remove (there's good and bad to that) and not your fault.

wish this was wider (didn't realize how big it was until I printed or i would have made it bigger.) I print a lot of multiple color and some change colors quite a bit, so have a lot of poop.

printed awesome

turned out prefect.loved how you print face down to save on the waste printing on the prime tower.

super cute and printed perfectly. I was able to fit 2 on the plate. only suggest is having it print face-down, so there's not so much waste of the prime tower.