Hi, here a little model of a Benchy.
It print Flat with nos supports,
If the slicer says it need supports, Ignore that it need supports.
When its printed, draw imaginaire dot lines on the benchy paint.
Its between these right dotlines you need to heat with a lighter underneath, back and forth until the temperature is just above 65 degrees.
Now you can fold it over and push on it to a corner of a table or shelf.
When it is cool down, you can heat between the other imaginary dot lines.
And repeat the previous steps
If you have any problem , let me know
Look also my cube paint
https://makerworld.com/nl/models/55104#profileId-56614
And please if you like it , share it and print it!!!! And show me your pictures. and rate the print profile please
Like it if you want and follow me for other items.
Comments welcome
I added also a print profile in mirror mode if you want