Nespresso Capsule Dispenser

This design was inspired by other printable models that repurpose the box, but it takes it further by creating a full dispenser that holds up to 10 capsules without needing the box, while also displaying the current capacity. The model is modular, allowing you to stack as many units as needed. Additionally, it includes a cap that reuses the box's label, allowing you to display at the top which capsules are stored in the tower.

Notes

• Print one Tower.stl and Cap.stl for each container.
• You will need around 255 of max height to print the tower.
• Each tower includes three holes for attaching joints, allowing you to connect multiple towers together and prevent them from moving independently.
• For the cap, remove the top portion of the original box and trim it to fit; it slides into the side of the cap.
• The design is made with tight tolerances in mind. If necessary, the cap and joints can be resized, and you may need to trim more from the box label if resizing the lid.
• The .f3d file is included, though it is missing the cap, as that version was lost.

Printing instructions

Printed on: Voron 2.4

Filament Used: Polymaker PLA Charcoal Black

Layer height: .2mm

Walls: 3

Infill: 40% Cubic

Supports: None

Brim: None