Search models, users, collections, and posts
DJI Avata 2 Bumpers
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
126
314
45
16
763
419
Released
Description
Compatible with propeller shields:
https://makerworld.com/en/models/997864
Print with PLA, and secure with cable tie.
- 17.5 g each
Why do I recommend a cable tie mount?
Properly tightened won't fall off with light impacts; if it breaks, it can be replaced in seconds.
Note about left and right files:
They are almost identical. After putting on the left and right cover, the front differs gently from the back. It is only a visual difference.
The side doesn't matter at all.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (45)