Egg Mold Smiley
Print Profile(1)
Description
>>All my prints at a glance // Take a look at my collections<<
Egg Shaper / Egg Mold / Smiley
Colors
- PLA white
Cook an egg hard for approximately 9-10 minutes, briefly rinse with cold water, peel it, and then place it into the printed mold
Place one logo at the bottom, another at the top, then twist to close
Allow the egg to cool, and it will never roll off your plate again
Cook an egg hard for about 9-10 minutes, then briefly rinse, peel, and add to the Shaper
Position one logo at the bottom, one at the top, and then twist to close
Allow the egg to cool, and it will never roll off your plate again
Please rate my print profiles / models... ♥
Please rate my print profiles / models... ♥
Boost Me (for free)
Thank you for your boost / feel free to boost me <3
Membership
If you want to support me, you can do it here. / If you want to support me, you can do it here.
Accessories for my coasters:
Coaster Stand / One Coaster | Coaster Stand / Four Coaster | Coaster Holder / Eight Coaster
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (2)