Egg Mold Heart
Print Profile(1)
Description
>>All my prints at a glance // Take a look at my collections<<
Heart Egg Shaper
Colours
- PLA white
Boil an egg for approximately 9-10 minutes until hard, quickly rinse it under cold water, peel it, and then place it into the printed mold
Position one logo at the bottom and one at the top, then twist to close
Then let the egg cool down, and your egg will never roll off the plate again
Cook an egg for about 9-10 minutes, then remove from the heat, peel and add to the Shaper.
One Logo in the bottom, one in the top and then turn over.
Allow the egg to cool and you will never roll off the plate again.
Please rate my print profiles / models... ♥
Please rate my print profiles / models... ♥
Boost Me (for free)
Thank you for your boost / feel free to boost me <3
Membership
If you want to support me, you can do it here. / If you want to support me, you can do it here.
Accessories for my coasters:
Coaster Stand / One Coaster | Coaster Stand / Four Coaster | Coaster Holder / Eight Coaster
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)