Ryobi 18v Battery Holder w/ Screw Holes

My dad and a few others were asking for a battery holder version that works with ordinary screws so here it is.

Logo is optional. There are two sizes. I mostly use Inland filament but when I printed the model with Bambu, the logo piece didn't fit well. I made a tighter fit that should work for most people. I also added a pry slot to use a knife or flathead to pull it off. I tried to hide the screw holes as best as I could. There are two versions of the holder itself. V2 is a little thinner and the bottom slope is different. I think I was trying to shave off more filament. V3 is more even all around and looks better in my opinion.

4 plates but 3 are optional. The print should take around 3h10m for just the holder. Logos are optional and take 20-25 minutes.