Search models, users, collections, and posts
Skateboard / Longboard wall hanger bracket
IP Report
Print Profile(2)
One or two brackets - No supports! 0.2mm, 30%, gyroid.
Designer
6.7 h
2 plates
Pennyboard Sized
1.6 h
1 plate
Open in Bambu Studio
Boost
469
1644
83
18
1.9 k
1.5 k
Released
Description
This is a strong wall mount for skateboards, cruiser boards and longboards.
It's mounted using screws with a shaft diameter ≤ 4mm (extremely common), you'll likely want to use rawl plugs / plasterboard anchors etc. depending on the surface you're mounting this to.
No supports needed and a strong print profile ✌
Plenty strong enough with PLA / PLA+, though use PETG or ABS if you prefer!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (83)