PAVO PICO - PAVO20 - DJI O4 AIR UNIT CANOPY
Print Profile(1)
Description
PAVO PICO - PAVO20 - DJI O4 AIR UNIT CANOPY (no aditionnal pat needed)
ASA-CF USED, WORK WITH ANY HEATPROOF MATERIAL (PETG-CF, PETG ETC…)
Canopy for the Pavo Pico compatible with the new DJI O4 air unit (lite version).
Total weight with 2S lipo 550Mah : 79g
Total drone weight : 47g
Design made to perfectly fit in the Pavo Pico (and the Pavo 20) with original screws and rubber pads.
Two parts :
- Bottom part for the O4 + Camera + anti-vibration pads
- Top part that clip on the bootom part for antenna + protection and easy air flow
Made for easy Air Flow, compatibility and lightweight. Only compatible with new DJI O4 Air Unit + Camera. Easy access to Type-C, boot / reset switch.
List of material needed :
-4x Canopy screw (Optionnal if Light weight)
-4x Rubber pads (in o4 box or pavo pico spare parts)
-4x Long plate screw with nuts (Those screws will both fix canopy + o4 + AIO board + crash Guard ) (Longgest screw you recieve with PAVO PICO or PAVO20 replacement parts)
-Screwdriver
Recommended Print :
No supports
0,16mm
2 Wall loop (lightest) (2,3 gram)
15% Infill (lightest) (2,3 gram)
ASA-CF (or any lightweight material + decent heatproof (PETG-CF, PETG). PLA may be too weak for +70°C O4 temperature.
If you have a TBS reciever or any other than ELRS, it can go at the same place.
PDF FILE INSCTRUCTION
Thanks !
Documentation (1)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (15)