Origami Crane

This is a remix of a origami crane from thingiverse to add two holes in the model so it can be hung as an ornament or any other application. Holes were added at 90 degree intersections so it can be hung from any angle you would like. This model prints without the need for any supports. Fusion 360 was used to remix the model.

If you like this model, check out the Origami Rabbit: https://makerworld.com/en/models/98647#profileId-105179

and the Origami Tortoise: https://makerworld.com/en/models/98663#profileId-105199