DIY 3D Scanner Turntable Spool Filament Bambulab
Print Profile(1)
Description
Required Components:
Threaded Inserts
Potentiometer
50cm USB Cable
Geared Motor
Bearing:
I used a 6200 Rs External/Internal/Height 30x10x10mm, but thanks to the parametric design you can use any bearing
NOTE: that it does not exceed the diameter of the fitting base
If you don't know how to reuse original Bambu Lab spools, this could be a creative way to recycle them and create a rotating plate
Below is how to customize the shaft to fit into the bearing:
1)Select the cylinder
2)Check uniform scaling
3)Enter the dimensions of your bearing's inner bore and set Z to 10.9mm + your bearing's inner diameter + 5mm
(example: my bearing measured 10mm internally, so I set it to 10.9+10+5=25.9mm)
To make the fitting base, always enter the parameters of your bearing
(example: mine measured 30mm external, 10mm internal, 10mm height)
and for wall thickness I used 5mm
Boost Me (for free)
Your boosts enable me to continue creating free objects, thank you for your support
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (7)