Blower for Parkside PWSA 20-Li C3 angle grinder

Convert your angle grinder into a blower. Made for Parkside PWSA 20-Li C3 angle grinder. 

• Danger! Make sure the product is strong enough, fan will run at high RPM! Fan may exlode when not strong enough. Use at your own risk!
• When using, make sure wheel is running freely before starting. 
• Makes a lot of noise! 

Assembly instructions:

1. Mount bottom shell using the metal plate and 3 screws that would normally mount your safety guard
2. Place bottom washer on angle grinder shaft
3. place blower wheel
4. screw on nut by hand, nut will tighten itself when you run the grinder
5. click top shell on bottom shell
6. make sure wheel runs freely!
7. Start at lowest speed to check if it runs freely and does not explode, increase speed slowly.