Search models, users, collections, and posts
case for EREMIT 12V 6Ah LiFePO4 battery
IP Report
Print Profile(3)
Version 2
Designer
3 h
2 plates
0.16mm layer, 2 walls, 15% infill
Designer
2.9 h
2 plates
0.16mm layer, 2 walls, 15% infill
Designer
2.9 h
2 plates
Open in Bambu Studio
Boost
26
47
15
5
62
27
Released
Description
Protective Case for a 12V 6Ah LiFePO4 Eremit battery.
The support is removed from the case with a small flathead screw driver and the battery is placed inside. The Lid is a snug fit an pushed onto the case.
Added v2
The new version should fit the battery nicer and the lid goes on smoother. Tank's very much for the feedback. By now the other two profiles are still there for completeness.
There are two profiles. One with supports all around which can be harder to remove and results in a tighter fit and one with supports only at the corner witch are easier to remove and result in a loser fit. For that one, be sure that your printer has apropiate bridging capabilities.
License
This user content is licensed under a
Creative Commons Public Domain
Comment & Rating (15)