ESC Receiver Tray Austar AX-8560, JJRC C8801 C8809
Print Profile(1)
Description
ESC & Receiver Tray to fit: Austar AX-8560, JJRC C8801, JJRC C8809
I designed this ESC & Receiver tray to hold the most common upgrades recommended for these crawlers, the Injora MB100 R80 ESC and the Injora T6DC Receiver (DumboRC X6DC reciver is identical)
**** This tray mounts to upgraded aluminium rear shock towers not the stock shock towers ****
**** You can easily find these upgraded shock towers on Ali Express ****
The ESC should be a friction fit and requiring no additional fixing but you can add velcro if desired.
The receiver is a little loose fitting to allow the antenna cable to be wrapped around one side, you may need some velcro to secure it in place.
This model is best printed with its rectangular base on the build plate. Supports will be needed to hold up the tray section.
I recommend printing with ABS / ASA or other material that can cope with being near to source of heat from esc/battery/motor.
PLA may be just fine but I haven't tested it.
You will need the following hardware:
M2.5 Nuts x4
M2.5 x14mm minimum length screws x4
Boost Me (for free)
If you found this useful, please give me a boost!
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)