Paper holder clip for Art/Shop/kitchen

This is a little paper holder that will neatly hold a piece of paper for quick one-handed use. Just slide a piece of paper in from the bottom and pull it out the side. This model can be scale but keep in mind the large it is the harder it will grab onto your piece of paper. Print 2 of them and use them on the corners to hold a large piece of paper.  Feel free to give me suggestions on how to improve my model or if you would like a different revision. If you would like to print the one that can magnetize onto things the slot for a magnet is exactly 33mm x 10 mm x 3 mm so if your magnet is smaller than that just drop it in when the print stops and let it seal it up when it resumes to give a clean finished design. 

There are 2 models one with a slot for a piece of double-sided sticky tape to go into and one that a magnet will slot into both require a print pause at layer 170 for the roller to go into.

If you are going to print this model you have to stop at layer 170 so that you can pull the roller off of the plate and drop it into the case. Do this through the slider on the right by going to layer 170 and right-clicking

 to add stop. 

uses, hold a piece of paper to your fridge, to the side of a car you are working on, or above your desk or even to your CNC machine. This little paper holder will let the paper easily slide in and out while holding with good strength and only needing one hand to insert and remove.