(Updated 2.0) Stone Age - Human Dragon - Blue Human Dragon - Yangchilos

Note: Please try to print with a smooth build plate; if using a textured plate, please adjust the support first layer expansion to above 10 or use glue to increase adhesion, otherwise, supports may not adhere firmly, leading to print failure!!

The model height is about 13cm, and the length is about 9.5cm

My color scheme:

Main body: All below are Bambu Lab PLA

Blue Charizard: Basic Blue + Matte Ice Blue + Basic Orange

Green Charizard: Basic Christmas Green + Matte White (hand-painted off-white) + Basic Green

Yellow Charizard: Matte Lemon Yellow + Matte White + Basic Orange

Red Charizard: Matte Dark Red + Matte Orange + Matte Lemon Yellow

Gray Charizard: Matte Gray + Matte White + Matte Dark Red

2025/10/30 Update: 2.0 print profile optimizes plate arrangement and supports, improving print success rate

2025/1/12 Update: Added print profile for the 2.0 version's matching base; when placing Charizard, align the toe tips first, then insert the heels to secure it. The base also has reserved 6*3mm round holes, which can be used with magnets in conjunction with the holes on the bottom of the model's feet

2025/1/2 Update: Added the overall forearm print profile for version 2.0, can be printed with AMS multi-color (results are excellent) or single-color printing followed by hand-painting fingernails

2025/1/2 Update: Added version 2.0 model, which is slightly taller than the old version

1. Upper arms and legs are Print in Place with the body, reducing obvious arm seams found in the old version

2. Fingers and teeth now have separate colors and parts, but they are very small; if you are confident in your craftsmanship, you can try it. Later, an overall forearm version will also be provided for AMS multi-color printing or hand-painting nails

2.0 Assembly Introduction:

Small parts diagram:

Recommended assembly order:

1. Glue fingers to forearms, let dry completely and firmly, then set aside

2. Abdomen, chin, toes

3. Forearms

4. Tail (3 parts)

5. Dorsal fin

2.0 new version versus old version comparison images:

2025/1/1 Update Preview: A new, larger version has been made, with arms, legs, and body Print in Place, which can reduce many seams. It is currently undergoing print testing. Those who want to print Charizard can wait another two or three days

Old Version Introduction and Installation:

Total height 10CM

1. When removing supports, pay close attention to the teeth, especially the very front ones, as they are particularly fragile

2. If using multi-color printing, when installing the chin, first align the very front of the mouth, then push the throat part upwards into the slot, otherwise, the teeth may easily break. (As shown below)