Stone Age - Tyrannosaurus Rex Series - Red Rex/Blue Rex/Gold Rex - Bardolan/Zudiros/Benedict - Roaring Pose
Print Profile(4)
Description
Note: Try to use a smooth build plate for printing. If using a textured plate, please adjust the support first layer expansion to above 10 or use glue to increase adhesion, otherwise, supports may not adhere firmly, leading to print failure!!
Update Records:
2025/10/30 Update: The print profiles for the three types of T-Rex have been optimized for plating and supports to improve printing success rate
2024/12/30 Update: Added print profile for the matching snap-fit display base, the finished product can stand up perfectly now
2024/12/30 Update: Added print profiles for the Green T-Rex, Earth T-Rex (Yellow T-Rex), and Aqua Blue T-Rex. For the Aqua Blue T-Rex, please hand paint the spots
2024/12/29 Update: Added print profiles for the Blue T-Rex and Gold T-Rex
2024/12/27 Newly added: Print profiles for the Red T-Rex and Black T-Rex. For the Black T-Rex's tongue, pay attention to color selection during printing
Boost Me (for free)
Your boost is my biggest motivation to update!
Introduction and Notes:
Height about 8.5cm, length about 12cm, the effect is really good
My color scheme: All of the following use Bambu Lab PLA
Main body:
Red T-Rex: Matte Scarlet
Blue T-Rex: Matte Sea Blue + Matte Orange
Gold T-Rex: Matte Lemon Yellow + Matte Orange
Black T-Rex: Main body Triple Green Matte Grey (their matte grey is very dark)
Green T-Rex: Main body Triple Green Macaron Green
Yellow T-Rex: Main body Matte Desert Yellow
Aqua Blue T-Rex: Main body Matte Sky Blue (Note: not Ice Blue)
After printing the first plate, do not rush to remove the parts. Remove and install them one by one only when needed for assembly. Otherwise, a pile of similar parts will drive you crazy
Except for the horn spikes on the back, there is almost no foolproof design for other parts, so make sure to dry fit to confirm everything is correct before applying glue
Teeth installation position, as shown in the figure below:
The installation positions for each toe and the horn spikes on the back are shown in the figure below: The toes correspond to the left and right positions, just install them in order. Of the two horn spikes on the legs, the longer one is for the rear, and the shorter one is for the front
Finally, please like, boost, and support it. The model will continue to be updated, and you can also post which one you want in the comments. If there is demand, I will make it in advance
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (15)