Search models, users, collections, and posts
LeapMotion 2 Shirt Clip
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
46 min
1 plate
Open in Bambu Studio
Boost
3
5
1
0
24
11
Released
Description
A small shirt clip to use with the Leapmotion 2 Hand Tracker.
I couldn't find any sort of clips or holders for the Leapmotion 2, but plenty for the original Leapmotion.
Requires double sided tape and a small piece of non-slip material.
By itself its a little too wide a birth for the device to be held, but adding the tape and non-slip pads it out and holds it firmly.
To be worn on the neck of a shirt or sweater/hoodie.
Uses 9g of filament. Printed with Bambu Lab PLA Basic.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)