Kobra 3 Camera Rizer

when you slice it the clip goes all wrong

It works perfectly, giving a better viewing angle allowing the entire bed to be seen in its entirety

Thanks for this. It raises it and modifies the angle just right. I'm not certain that the USB cable is long enough to accommodate using this on the Kobra 3 Max if Z goes all the way to the top but 99% of my prints don't come close to that so for now I'm using without testing the length... I will get around to that and report back.

what camera housing is used for this please?

Lovely item Is there a clearer photograph of the assembly, I can’t figure it out now thanks

The print head hits the support

It printed out great and provides a much better view.

Just installed. However, the print head bumps against the riser. Thus unusable. Or did I do something wrong? Assembled exactly as in the picture

Printed great without any issues and works as well. Thx!

Great model, quick and easy to print. Big improvement over original camera position!