Indoor/Outdoor Party Caddy

This is a nice caddy to set out your paper plates (up to 8 inch), napkins, forks, spoons, and knives all in one place at parties.

I recommend printing it in PETG if you are going to use it at outdoor parties.

Be aware this is a very large print that uses pretty much the full print area of a 256x256 printer.  If you have not done this before and are on a P1P,P1S, or X1C, you will need to follow the instructions here:  Print volume limitations, and how to use the full build volume 256x256x256mm³ | Bambu Lab Wiki

The included profile has removed the bed exclusion area like the link says and includes the change below to the nozzle load line:

;===== nozzle load line ===============================
M975 S1
G90
M83
T1000
G1 X18.0 Y1.0 Z0.8 F18000;Move to start position
M109 S{nozzle_temperature_initial_layer[initial_extruder]}
G1 Z0.2
G0 E2 F300
G0 X240 E15 F{outer_wall_volumetric_speed/(0.3*0.5)     * 60}
G0 E0.2
G0 Y1.5 E0.700
G0 X18 E15 F{outer_wall_volumetric_speed/(0.3*0.5)     * 60}
M400

I would recommend using whatever glue you normally use to maximize adhesion.

I would also recommend pre-heating the bed for ½ hour before starting the print to get the temp at the edge of the bed closer to what the middle is.

The optional feet are included on a separate profile so it doesn't have to include the full print bed changes.  They need to be glued on.

If you like this model, you may also like my Party Cup Holder:

Party Cup and Pen Holder by Engineered Reality - MakerWorld