Search models, users, collections, and posts
ESC Holder Tekko32 F4 45A
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.4 h
4 plates
Open in Bambu Studio
Boost
0
2
0
0
3
1
Released
Description
Simple and lightweight but efficient ESC mount
This is a mount I designed for the TEKKO32 F4 45A. The “clamp part” is printed from PC due to the heat generated by the ESC and the heat tube. Depending on how hot your ESC gets, you should choose an appropriate filament. I wouldn’t recommend anything below ABS or ASA.
The F4 45A measures 32x17x4.5 mm.
The design minimizes the contact surface between the mount and the ESC. The base plate is printed from PETG and is intended to be glued directly into your model. There are two versions, a flexible one and a sturdy one.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)