Search models, users, collections, and posts
Dig Octa + Meanwell 600 Mount
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
14
34
5
4
81
49
Released
Description
This is a simple mount for a QuinLED Dig Octa to screw into the sides of a meanwell 600 powersupply. Provides a little spacing between the bottom of the mount and the power supply to make sure heat isn't getting trapped.
The V2 model is hollowed out a bit to lower the amount of filament used BUT is a little less rigid. I left .5mm of material under the dig itself to prevent shorts.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (5)