dragonfly articulated with moving wings - Free 3D Print Model

Search models, users, collections, and posts

tomo3D

Miniatures>Animals

IP Report

GIF

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

H2D

H2D Pro

H2S

P2S

H2C

X2D

A2L

A1 mini

0.2mm layer, 2 walls, 15% infill

Designer

2.8 h

2 plates

4.9(82)

0.2mm layer, 2 walls, 15% infill

2.2 h

2 plates

4.5(2)

Open in Bambu Studio

Boost

943

2090

110

1.3 k

766

Released

Description

fine for a 0.4 nozzle at this scale

works great with regular pla/petg/pla matt

with pla matt (with it being rough in feel) it might need the button on top to be pressed a few times to work the mechanism in, the more its pressed, the easier it will be to press,. Make sure the wings are glued in and dry before working it in.

just glue the legs on using the location pegs and then glue the wings in.

have not tried silk filament on this model so not sure if that will work or not for the mechanism

the filament used for the body is eryone dreamland

the filament used for the wings is eryone blue and yellow dual colour

Apart from that, print and enjoy

dragonfly

articualated

Comment & Rating (110)

@LayersWithLily

We had a dedicated bug stream on Twitch and encountered your model! The flapping wings are so cool. We were able to print the wings in two colors, and it came out so cool! Thank you for sharing. You can watch a clip of the livestream here: https://www.youtube.com/shorts/5K6L9rvXT-I

The designer has replied

@tomo3D

Cool video. glad you like the model :)

@user_3835718648

Print Profile

0.2mm layer, 2 walls, 15% infill

very!!! very nice

The profile uploader has replied

@tomo3D

nice work 👏

@disbt1gg3r

My finish wasn't the greatest, wing movement button snap when I press it down, wing didn't move as much as his video posted

The designer has replied

@tomo3D

I'm just looking at the finished model you posted and the filament you've used looks like it had alot of moisture in it. You can see the spits and bubbles in the finish. try drying it in a filament dryer or use new filament. Always put your reel of filament back in the sealable bag it comes with along with the moisture absorbing sachets after you finished printing.

@disbt1gg3r

Replying to @tomo3D :

Noted, ill will run it in the dryer for 4hrs again thanks for the tip

@THINK3DAU

Print Profile

0.2mm layer, 2 walls, 15% infill

This design is so cool! And the print came out so nicely 🤩 Thanks so much 🙏🏼

The profile uploader has replied

@tomo3D

👏

@user_905974544

Print Profile

0.2mm layer, 2 walls, 15% infill

Had a great time making this. Only regret was not using adaptive layer height on it, the accents on top came out a bit rough. turned out fantasic with coextrusion filaments