Headphone stand, glasses stand) Spiderman Venom style head cutout

This is a revised version of a previous author’s (https://makerworld.com.cn/zh/models/239501#profileId-173906)Spider-Man bust. After printing it, I intended to use it as a headphone stand,

but I discovered it wasn’t quite compatible with my headphones (Sony WH-1000XM3). They seemed stretched, and prolonged use would likely cause deformation,

so I measured the natural curvature of my headphones and adjusted the proportions for a snugger fit without excessive bulk. The hollow design also allows me to conveniently hang my Huawei glasses on it or place them on the model’s face (an unexpected bonus!),

The revised dimensions(approximately 13.6 centimeters maximum width, 19 centimeters from the nape to the front, and under 20 centimeters in height)prevent it from looking out of place on a desk and make it ideal for desktop decor, even without using it for headphones and glasses.

I personally used Silk Purple and Black (with slight stringing) PEGT filament on a Bambu A1 printer without any issues. You may need to adjust your material temperature settings; the previous author also successfully used PLA.

!!! Remember not to forcefully detach the entire model. When cleaning the base, proceed slowly and use a sprue cutter to carefully remove any excess material to prevent breakage!!!