Sumie Hueforge Decor
Print Profile(2)
Description
I have two seperate print files for AMS users. So you dont have to worry about filament changes. But if you dont have AMS you can use this settings and filament swap instructions.
For the piece on the left, designed to be a bookmark use this settings.
Print at 100% infill with a layer height of 0.04mm with a base layer of 0.16mm
The Model is 70x124.4mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2mm and the Actual Depth is 2mm
Filaments Used:
PLA+ Esun Black Transmission Distance: 0.4
PLA+ Uzy Red Transmission Distance: 5.4
PLA+ Esun Bone White Transmission Distance: 5
PLA+ Esun Cold White Transmission Distance: 2.4
This print uses 4 unique filaments
Swap Instructions:
Start with Black
At layer #14 (0.68mm) swap to Red
At layer #17 (0.8mm) swap to Bone White
At layer #45 (1.92mm) swap to Cold White for the rest.
For the piece on the right, use this settings:
Swap Instructions:
Start with Black
At layer #14 (0.68mm) swap to Red
At layer #15 (0.72mm) swap to Bone White
At layer #42 (1.8mm) swap to Cold White for the rest.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)