CARRERA SLOTCAR D132/D124 - Shoulder / Roadside R1

I started modeling these borders a few years ago, Now I decided to improve these borders with two-color borders.  

Of course, it is possible to print them in one color.

The recommended material is ABS / PETG.
(I'm not sure PLA would have the same resistance.)

!! Print on textured board !! The surface of the edges is then very similar to the original parts of the track

A printing profile for X1C is included, also tested on A1 with PETG material (I think the models will also fit on the A1 mini).

The print speed is adjusted in the profile and for a better result, I recommend leaving the supports on.

In the case of disabled supports, I recommend editing G-CODE = M220 S050 on layer 37 (this will slow down the bridging for better detail and less cleanup)

New in 19.1.2025:

I just added a new print profile for the A1mini, including settings for how it should be printed. I personally tested the print, if necessary, it is possible to glue the lock with instant glue, however, I believe that it will hold in the assembly even without it. Have a lot of fun...

 I'll still be adding to the transition from Full Edge to this Split in the future..for R1

New in 31.1.2025

Internal loops for R1 / half width (HalfColor) including profiles for A1/XC/XE and also for A1mini are made

I add a separate profile to each version, in each profile there are both sides/directions.

New in 2.2.2025

Added a new print profile that includes full shoulder widths in a color variation. It contains standard straights 1/2, 1/3, 1/4, ending and beginning. incl R1 30(in/OUT) R1 60in (outer edge consists of two R1-30out)
They can be connected with a half-width via an adapter (this is included in the main printing profile)

PS:

If anyone has an idea for another modification, write it in the comments, in my spare time (there are not many) I can prepare other variations of R2-R4 according to the number of requests, but always within a few weeks, not days.