Search models, users, collections, and posts
Yaesu 991A Microphone Holder
Remixed by
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
22 min
1 plate
Open in Bambu Studio
Boost
6
41
1
0
55
36
Released
Description
Summary
Yaesu 991A Microphone holder, mounts to the side of the radio in the two pre-existing mount holes, requires 2 M4-0.7 x 10MM screws.`
991a-mic-bracket.stl: the mounting bracket with the microphone holder attached
bracket.stl: the bracket as a standalone stl if you wanted to try mounting something else to it.
Print Settings
Rafts:
Doesn't Matter
Supports:
Yes
Notes:
Supports not necessarily required, but if you don't use them the fit for the microphone is quite snug and depending on the filament used you may have to file some blobs down to fit the microphone in properly
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)