Search models, users, collections, and posts
Playstation 2 Slim vertical stand (PS2 slim)
IP Report
Print Profile(4)
0.12mm layer, 3 walls, 15% infill - V2(increased tolerances)
Designer
1.1 h
1 plate
0.12mm layer, 3 walls, 15% infill - V1 (original model)
Designer
1.3 h
1 plate
Optimized stronger print
1.4 h
1 plate
PS2 Slim 9000X
1.6 h
1 plate
Open in Bambu Studio
Boost
483
1076
91
33
1.3 k
878
Released
Bill of Materials
Maker's Supply Kits and Parts
Select all
Description
This stand was made for SCPH-700xx model
For SCPH-9000x model there is a "PS2 Slim 9000X” profile from @RubenDM17.
I can't check if it fits, so I am waiting for your feedback.
Make sure you have a right one!
SONY PlayStation 2 Slim vertical stand with holder for 4 memory cards.
M3x12 hex screw needed.
Printed with PLA.
There are 2 models:
V1 - Original model. Works fine for me. Base width is 28.2mm
V2 - Tweaked model with extended tolerances. Base for console is 28.5mm wide. Pegs are narrower for better fitment.
Studs are reinforced with 100% infill modifiers.
3 walls for better strenght.
15% infill is enough, but you can use more if you want to add more weight.
Screw hole has support for better visuals but you can print it without any supports.
Card holder tested with original memory card and fitment is fine, but i can't guarantee perfect fitment for non original cards.
Boost Me (for free)
Boost me if you like this model!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (91)