Stuffed Fables proxy models
Print Profile(1)
Description
Models for the board game Stuffed Fables
Created in Blender, using internet images as references, therefore not scanned. Over 100 hours of work to bring the game to life, or to replace any missing pieces.
Everything was printed with a 0.4mm nozzle, 0.08mm layer height, and eSUN PLA+. The 0.2mm nozzle is unavailable for purchase at the store; therefore, there is significant room for improvement in the figure's print quality.
Tree supports can be used, print the pieces flat, or incline them at 45º and print at 0.16mm layer height. The results are also very good, and some figures like Piggle, Theodore, Stitch, and those with thin parts may be easier to remove supports from.
As with any hobby, approach it patiently. The numerous supports can be challenging to remove; do not blame the model. The same applies if your printer scrapes and removes supports during printing, resulting in a poor print. These have been printed on an A1 and a Creality K1; you can always use your own print profile.
Increase the Z-distance for supports; in this case, for a 0.08mm layer height, they have a 0.16mm distance.
The photograph shows Piggle printed at 45º and with a 0.16mm layer height to demonstrate different results.
If you believe a figure requires modification, let me know, and I will do my best to adjust it within my capabilities.
Best regards and happy printing
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (7)