Search models, users, collections, and posts
Bed Slat Frame Support
IP Report
Print Profile(1)
0.24mm layer, 6 walls, 50% infill, 75% infill stress areas
Designer
2.8 h
1 plate
Open in Bambu Studio
Boost
10
11
0
1
9
1
Released
Description
This is a simple support clip to secure my bed slats from shifting away from the bed frame. This fits a bed slat that is approximately 7.5cm x 1.5cm and a frame that's under 1cm wide and 5cm high.
This is probably over-engineered, but I don't like my prints to fail, so this could likely support quite a bit of lateral force.
I've included the Fusion 360 model so edits could be made to the sketch. If you'd like me to make edits to the design, send me a request and I'll upload the new print.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (0)