Ultra-thin card phone stand. Only 5g of filament!
Ultra-thin card phone stand. Only 5g of filament!
Boost
258
478
130
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
18 min
1 plate
0.2mm layer, 2 walls, 15% infill
18 min
1 plate
Open in Bambu Studio
Boost
258
478
130
4
779
792
Released
Description
No more fiddling with resting your phone against random objects when bored on a flight of cafe after realizing you don't have a phone stand with you.
Credit-card sized and ultra-thin to fit in any wallet.
PS: only works with the phone in landscape mode, it's not tall enough to hold the phone on portrait mode.
STEP file included, feel free to remix and share, but please use the attribution feature.
Also check the more robust version for heavier phones and either horizontal or vertical position:
https://makerworld.com/en/models/112497
And phone support with vintage design and speaker amplifier:
https://makerworld.com/en/models/30546
Comment & Rating (130)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
ottimo progetto. stampato con PLA senza problemi. complimenti
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
It’s way too small to hold any phone and it breaks too easily.
The designer has replied
0
Reply
Sorry about that. I made a more robust version, if you would like to try:
https://makerworld.com/en/models/112497
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed well (small surface defects but I think that was due to my own printer) had a good amount of flex to it!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed great, like the idea. has a limited number of uses unfortunately, but worked great when I used it
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works really well. Printed in Bambu Basic PLA.
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very good
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Idee ist gut aber man Handy wird nicht gehalten mit dem Quadlock Case.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Prints very good! I made the Mittagessen and used PLA tough. I don't reccomend it because it semes like its not going to be bend a lot before falling apart.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Related Models
© 2024 MakerWorld