Search models, users, collections, and posts
XTouch (Mini DS18B20 Sensor) Chamber Temp Enclosure
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
12 min
1 plate
Open in Bambu Studio
Boost
2
4
0
0
10
2
Released
Description
This enclosure fits the DS18b20 temp sensor I was able to order from Amazon. It was a few dollars more than AliExpress, but I had it in 2 days. It's smaller than most temp sensors, so I came up with a custom enclosure. It integrates perfectly with the XTouch Controller on my P1S.
- Double-Stick tape used to secure sensor to the bottom of the enclosure. A drop of superglue to seal the case.
- Link to the DS18B20 sensor used: https://a.co/d/fwWVSxL
Project link: https://github.com/xperiments-in/xtouch
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (0)