'Mountain DisplayPad' mount for SVÄRTA

*above pictures are of the v2, I was careless and had damaged the top part of the print, therefore the glue in the pictures.
-------------------------------------------------------------------------------------------------------------------------------------------------------------

A mount for the Mountain DisplayPad for the SVÄRTA IKEA loft bed.
 

If you want to increase the angle of the base plate further, you will need to manually adjust the model. (Not a difficult operation)

If DisplayPad sliding onto the interface is too stern for your liking, you could sand down the top-face to create more clearance for the rubberized pad's the DisplayPad has on its underside.

Changelog:
v2.1

• Increased Thickness of Back Walls
• Increased Infill (15% → 20%) to strengthen walls

v2

• Optimized design for Less Material used and Easier Support Removal
• Angled Base Plate for Easier Use
• Added Direct Interface for the DisplayPad mounting Rail

v1

• Initial Measurement confirmation Print