Search models, users, collections, and posts
Frag Coral Photo Booth (Magnetic)
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 30% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
68
151
6
2
88
40
Released
Description
This super simple print massively helps show off the beauty of your coral frags with it's backdrop helping with both focus and getting your coral's colours to pop!
The magnet I used is a Rubber Coated N42 Neodymium Magnet (21.5x6.1mm) which holds the booth securely even through thick glass. Glue it to the cut-out on the back of the model with a dab of super glue and you're ready to get some photos taken! Post some of your coral pics in the make section if you can!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (6)