Search models, users, collections, and posts
Rack system for miniature painting case
IP Report
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
16.8 h
4 plates
Open in Bambu Studio
Boost
46
150
6
4
55
10
Released
Description
I made a rack system for a custom miniature painting case i built.
Each box is 23cm wide, but you can scale it on the Y-axis to change the width. If you dont make them to small, the tabs that slot into the rack should still work!
Each slot on the rack is 3 cm apart, so the bigger boxes cover to slots, while the shorter one only covers one.
Everything printed on a A1 in PLA with the 0.4mm strength profile.
No supports needed.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (6)