Short AR Mag Pouch V1.1 (REMIX)

Short AR Mag Pouch V1.1 (REMIX) by Qwerm

A remix of FecalDisco's "3D printable molle universal rifle magazine pouch" that is shorter, allowing it to hold 10 and 20rnd AR15 magazines. The MOLLE attachment was also replaced by a belt hook from PhilPhisher's "PPDS Ghoulster".

V1.1:
-Increased mag retention.
-Slightly easier mag insertion.
-Moved the cord lock to the front to make it easier to attach the pouch to your belt.
-Uses the same unmodified belt hook from the PPDS Ghoulster.

Print orientation: Print everything on it's side.

Settings used:
Material: PLA+
Extruder Temp: 210c
Bed Temp: 60c
Layer Height: 0.2mm
Wall Line Count: 5
Infill Percentage: 100%
Support: None

Materials Needed:
1/8 Inch Shock Cord
Cord Lock
2x M5x8 Screws
2x M5 Nuts

Thank you for checking out my model. And thank you to everyone who likes and boosts my models, it helps me out a lot more than you may think!