Search models, users, collections, and posts
Euphonium
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
1 plate
Open in Bambu Studio
Boost
255
618
55
15
818
362
Released
Description
This is a Euphonium That is about 5 ½ inches long. I made it in SolidWorks and tried to be as accurate to the real thing as possible. Some detail is lost in the print but I'm sure would show up better if scaled up. The print setting could also be tweaked in the future as the supports are a little tricky to remove, and the quality was a bit fuzzy, but I was trying to ensure the valves would not snap off will removing the supports. I am open to suggestions and help cause i really like this model
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (55)