Search models, users, collections, and posts
Chaos Emerald with Stand
IP Report
Print Profile(1)
Emerald 5% cubic infill, Stand 50% Grid infill
Designer
2.4 h
2 plates
Open in Bambu Studio
Boost
403
953
85
22
1.2 k
864
Released
Description
Did you enjoy Sonic 3? Do you want a life size Chaos Emerald to hold? Perfect because I just made a life size emerald with a nice looking stand.
The Emerald itself should be printed flat side down. You should try to use a sparkly or translucent filament to get the full effect. If you use translucent, use cubic infill at 5% to get a good “Emeraldy” texture on the inside.
The stand will print great at any infill but if you want to go strong, 50% is more than enough and should only add a couple of minutes to the overall time.
NOTE: The black spot on top of the emerald is not part of the print, I had leftover black on my nozzle and it stuck.
If you like my designs, please consider taking a look at my Patreon
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (85)