Search models, users, collections, and posts
Technical Drawing Compass
IP Report
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.3 h
3 plates
Open in Bambu Studio
Boost
11
24
1
0
4
0
Released
Description
It's a rather simple circle. Built for technical drawing and drafting. It can accommodate pens with a diameter of up to 12 mm.
Additional Parts needed:
- 2x 8mm Diameter Aluminium rod
- 1x M4*30mm screw
- 1x M4*20mm screw
- 3x M4 Nuts
- 1x 8mm (Diameter)*16mm Compressed Spring
- 1x Pointed Needle 2mm diameter
Filament used:
- TPU (for Einschub, needs to be printed twice)
- PLA
Assembly:
- press the rods into the middle part
- slide the pen holder on the rods
- attach the end cap
- lay the TPU parts into
- with a M4-Nut; screw the disk onto the M4*30mm screw
- with the spring, screw the clamper onto the pen holder
- get the small pen clamp, with the M4*20mm Screw and a M4 Nut, lay them into the pen holder
- Press fit the pointed needle into the middle part
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (1)