Search models, users, collections, and posts
Dino-Prints
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
12.5 h
4 plates
Open in Bambu Studio
Boost
13
34
2
0
40
13
Released
Description
What the heck has been walking here? Some kind of dinosaur? These scary looking feet will leave scary looking footprints in the sand. They work best in just slightly damp, looser sand.
Prints easily without supports in your favorite filament. Print one left, one right, and two handles. The handles simply press into the backs of the feet. The feet are about 185mm long (they'll fit on a Prusa mini) but can be easily scaled up or down as desired.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (2)