Search models, users, collections, and posts
Lineman's Pliers 2 Sizes
IP Report
Print Profile(1)
2 sizes 0.2mm layer, 3 walls, 10% infill
Designer
6.5 h
2 plates
Open in Bambu Studio
Boost
38
110
2
1
90
44
Released
Description
-Some of the slicer settings are abnormal but as you can see in the last photo a lot of work and prototypes went into making this, and these settings had the best results
-Print time is only so long because I have 2 sizes on different build plates
-A drop of superglue keeps the endcap of the pivot attached to its other half
-For best results the pivot parts are assembled in the same orientation as printed, so the ironed top surface faces up.
-Currently don't have gray/silver filament so I used a grey/silver sharpie on the top surface.
-Not for actual use, just a novelty
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (2)