Bo - 105 - OMP M2 EVO

Project Info:
OMP M2 EVO Drive

Flight Weight: 535g

Material PLA

Printer Bambu Lab X1C – generally with standard settings

Print Bed 1:
Front Cabin – 15% infill
Smooth surface
Tree support structure

Print Bed 2:
Main Cabin – 15% infill
Smooth surface
Tree support structure

Print Bed 3:
Tail Boom – 15% infill
Wing side parts
Connecting tube to main cabin
Smooth surface
Tree support structure

Print Bed 4:
Slider to drive – 60% infill
Smooth surface

Landing Gear – 45% infill
Smooth surface

Assembly Instructions:
Connect cabin parts with neodymium magnets
4 pieces 8x8x8mm 5kg force

4mm aluminum landing skids
Drill 1.5mm holes in the cabin floor for the landing gear
Screw M2 x 6mm directly into the PLA

Tail rotor installation with OMP adapter – motor cables need to be extended by approx. 10cm
Glue the tail boom only after installing the lighting

The drive can be attached to the slider with the original screws. I did not further secure the slider in the fuselage

Lighting from Ledprofishop.de item no. 03-0001-0001 €12
Consisting of searchlights, landing lights, red rear flasher, red/green for rear wing
Power supply approx. 4V from the Lipo balancer connector