Hueforge - Black Labrador Cutout

Simple HueForge cut-out. Can be put above your door or atop a picture.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 200x150mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.2mm

Filaments Used:
    PLA PolyLite Black Transmission Distance: 0.3
    PLA BambuLab Basic Blue Gray Transmission Distance: 3
    PLA Jessie Premium Tan 64 Transmission Distance: 1
    PLA PolyLite White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
    Start with Black
    At layer #9 (0.8mm) swap to Gray
    At layer #10 (0.88mm) swap to Tan
    At layer #14 (1.2mm) swap to White for the rest.
 

My first submission here and first HueForge, so any recommendations/tips are welcome :)