Scarpa F1 Insole Spacer

Welcome Skimo enthusiasts!

If you are suffering like me from skinny, low volume feet and owning a Scarpa F1 boot look no further. Here is a fitting Insole heigth spacer fitting between the liner and the boot.

The model is fitting for a MP 27,5 Boot. By scaling the Sole you should be able to fit it for different Boot Sizes

There are two models:

Model 4mm has a height of 4mm is a flat Version

Model 46-27 has a height increase of 2,7mm at the toes and 4,6mm at the heel which was fitting perfect for me

You can modify the height by your own or get in contact with me for a customized Version

I Printed the Soles out of standard PLA with 5mm Walls, 15% Honeycomb Infill, 2 Bottom Layers and no Top layers. The like this printed Flat side goes against the Liner, the open Honecomb Structure should face the bottom of the boot. If you are drying the Boots regularly on a heating System (which you should not do anyhow) you can print the sole out of an higher temperature resisting Material

If you like my work or need something speciall let me know and follow me!

if you want to buy me a coffe, here is my ko-fi page: https://ko-fi.com/i1985