Search models, users, collections, and posts
FC350BJ_110v Motor Controller enclosure
IP Report
Print Profile(0)
Add the first print profile to earn points
Boost
1
1
0
0
0
0
Released
Description
Summary
I needed a new enclosure for my Sieg X2's motor controller since I put a 4in C-Channel on the back of the column. It prints in a number of pieces to fit on a 9x6 printer easier. requires M3x.5 x 8mm screws here and there. Mostly SHCS but a few of them are flat heads. If you can't figure out which ones just message me.
There's also provisions to include a C6 spindle controller inside so you can have MACH3 control your spindle for a bit safer operation.
License
This user content is licensed under a
Creative Commons Attribution
Comment & Rating (0)