Search models, users, collections, and posts
Eufy Security Solo P24, S220 Stand sizable
IP Report
Print Profile(1)
PLA 0.2mm layer, 2 walls, 15% infill
Designer
3.4 h
1 plate
Open in Bambu Studio
Boost
9
31
0
1
33
8
Released
Description
Summary
This is a stand for Eufy Security Solo IndoorCam P24 and S220. It will raise your camera 200mm (8"). It is design to be printed without supports. You can make it any height less than 200mm by lowering the part into the build plate as shown in the picture. The cut out was off for the light on my first print. I adjusted the cut out to be centered.
Print Settings
Rafts:
No
Supports:
No
Resolution:
.28
Infill:
20
Filament: Any Any
Any
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (0)