Can Holder for Coolers
Print Profile(2)
Description
Do your drinks roll around in your cooler or fridge when travelling?
This can holder will stop your cans rolling around and getting damaged and as a bonus its stackable. The next layer of cans locks into the top of the cans on the lower layer to stop them moving around. Stacking your cans saves you room in your cooler or fridge.
Sized to fit Australian 375ml cans (diameter 66mm and top of can 54mm)
Supports are only needed on the underside of each can, no supports are needed for the holes in the sides
Two versions have now been uploaded 6 cans and 4 cans, you can stack Two of the 6 can or Two of the 4 cans on top of each other. If you want 10 cans you can have 6 on the bottom and stack 4 on top.
There are 2 profiles uploaded.
Profile 1 - Original 6 Pack with Two plates
Plate 1 is PLA and has PETG as the support interface (just to give a nice finish on the underside)
Plate 2 is all PLA.
Profile 2 - New 4 Pack with Two plates
Plate 1 is PLA and has PETG as the support interface (just to give a nice finish on the underside)
Plate 2 is all PLA.
Looking for a holder for smaller cans (250ml) check out my other model here Can Holder for coolers (250ml cans) by fillodonnell - MakerWorld
Boost Me (for free)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (58)