Search models, users, collections, and posts
X1C Door Magnet Side Seal (Final Version)
Remixed by
IP Report
Print Profile(2)
TPU version ( no magnet hole tolerance, no glue needed )
Designer
1.2 h
1 plate
Not TPU version (magnet hole tolerance +0.1mm)
Designer
1.1 h
1 plate
Open in Bambu Studio
Boost
14
37
1
0
30
20
Released
Description
Modified Version of Al.varo's P1S Door Shield
It covers longer range than the original
Just Print ( Just 1 Plate, TPU ≤ 95A Recommended ) and Put Magnets ( Diameter = 3mm, Thickness = 3mm )
No Tapes on the Glass or Enclosure & No Stress on the Door Hinge
Also other materials ( PETG, ABS, ASA, etc ) are fine to print and use
* Improved Points
- Added Orthogonal Wall to the Door
→ More Rigid Line between Magnet Points
→ The Door Slightly Pushes the Previous Version of the Seal, So that Added part covers the gap and Fits to the Door Fully Opened
→ More Stable Printing as Bed Facing Area goes Wider
* I am Very Satisfied with this Final One and Recommending you to try this out
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
Comment & Rating (1)