Search models, users, collections, and posts
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
35
69
16
0
173
110
Released
Description
The problem with this type of model is that it is thin and tall. This means that the toolhead will wiggle it around when printing the out layer, causing quality issues and even print failure.
The changes described below mitigate these issues and provide a far better print quality when printing this model vertically.
- Reduced Sparse Infill Density to 15% to avoid solid infill and therefore, improve print quality when the toolhead is printing the top part
- Increased width at the base of the stem by introducing a cone shape - this helps with reducing the wiggles introduced by the toolhead.
Comment & Rating (16)